Dome CXtra User's Guide download pdf (Page 78)

74 | Dome CXtra

To set up entries on the Photometers tab

1 Select a photometer from the pull-down list. Select Other if your

photometer is omitted from the list.

NOTE: All photometers must adhere to section 7.1 of the DIN

specification. When you select Other, you must manually enter

the measured values in the test wizard dialogs.

2 If you selected Other in step 1, type the name of the photometer

manufacturer in the Manufacturer field.

3 Enter the photometer serial number in the Serial Number field.

4 On the COM Port pull-down list, select the COM port used to

connect the photometer to the computer.

5Click Apply.

If you selected Other in step 1, a message reminds you to manually

enter measurement values while conducting the tests. Click OK to

close the message.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 125 126

No comments

Dome CXtra User's Guide Page 78